Skip to content
All Samples 50% Off

Vanity Backsplashes

Sort by

View

Load more

Frequently Asked Questions

Do I need a backsplash if I already have tile behind the vanity?

No. If tile runs down to the countertop the joint is already covered, and a stone backsplash over tile would sit proud of the wall. Use silicone at the counter line instead and leave it at that.

What height are these backsplashes?

They are the standard four inch return, which protects the wall from splash without reaching the mirror. If you want a taller run of stone, a fabricator can cut a full height piece from a slab, but that is a custom order rather than an off the shelf part.

Will the backsplash match my countertop exactly?

If you order the matching colour, yes. They are cut from the same engineered slabs, and unlike natural stone the pattern is consistent from batch to batch, so a Eternal Marfil backsplash matches a Eternal Marfil top.

How is a vanity backsplash installed?

It is set on a bead of silicone against the wall and siliconed along the counter joint. No mortar, no grout, no fixings. Hold it in place with painters tape while the silicone cures, usually a few hours.

Can I use one as a side splash?

Yes. Where a top runs into a return wall, a piece cut to the depth of the counter does the same job on the side, and it is the joint most likely to see standing water. Order the width closest to your counter depth and have it trimmed if needed.

Vanity Backsplashes

The strip of wall behind a bathroom faucet takes more water than people expect. Every hand wash throws a fine spray at it, and drywall paint gives up long before the vanity does. A stone backsplash solves that, and it does a second, quieter job: it covers the gap where the countertop meets a wall that is never quite straight.

These are cut from the same quartz and composite slabs as our vanity tops, in the same colours, so a Charcoal Soapstone top gets a Charcoal Soapstone backsplash with the same surface and the same edge. Widths run from 24 to 72 inches, matching the standard cabinet sizes, and the height is the usual four inch return that sits under a wall mounted mirror without crowding it.

When to use a stone backsplash and when to tile

A stone backsplash is the right call when you want the top to read as one continuous piece and you do not want a grout line at the counter. It installs in minutes with silicone, it is a single joint to keep clean, and it does not date. Tile is the better call when the wall behind the vanity is the feature of the room, when you are running the material up to the ceiling, or when you want pattern rather than a plain field.

  • Cut from the same slab as the matching countertop
  • Standard four inch height, sized 24 to 72 inches wide
  • Installs with silicone, no grout line at the counter
  • Wipes clean with soap and water, no sealing
  • Also works as a side splash where the top meets a return wall

Side splashes for a top that meets a wall

If your vanity sits in an alcove or hard against a return wall, order an extra piece for the side. Water runs down the end of a top and into the joint far more often than it runs up the back, and a side splash stops that joint from staining. Cut pieces can be trimmed on site by any stone fabricator if the length needs adjusting.

Finishing the wall above

Above the backsplash the wall is yours to decide. Paint is the simplest and the easiest to change later. If you want the room to do more, our marble tile and mosaic ranges include the small formats that suit a vanity wall, and bathroom tile collects everything rated for a wet room. To see the vanities these splashes were cut for, start at bathroom vanities.

Cart

Your cart is empty.

Added to cart

Complete your project

View cart