Menu
Contact us
- 1-800-622-8708
- sales@stonetiledepot.com
- 8:00 AM - 8:00 PM EST
Contact us
* Usage recommendation must be confirmed by your installer and depends on application, installation methods and general suitability. Stone Tile Depot assumes no liability from any installation and usage recommendations.
Roma Almond is a 12x24 porcelain tile with a travertine look in a matte finish, 8.5 mm (5/16 inch) thick.
Roma reproduces Italian cross-cut travertine using Del Conca's Trace dimensional glaze, so the face has real texture under the hand. It comes in White, Almond, Gray and Nut, from 24x48 to 4x12, with an Archetti arch decor, mosaics and bullnose.
At 12x24, the tile can run in a brick pattern, a one-third offset or stacked vertically on a wall.
Del Conca's Trace process builds real relief into the matte face, so the texture catches light like natural stone. The color runs through the body of the tile, so a chip shows the same tone instead of a light clay base. Shade variation is moderate: tone and pattern change from piece to piece, as in natural material. Del Conca rates the face at 0.51 DCOF wet or better, which meets the ANSI A326.3 minimum for level interior floors that get wet.
Rectified edges, ground square after firing, allow a tight grout joint. Each box holds 8 pieces, 15.5 sq ft, about 61 lb, and orders round up to full boxes.
Also in Roma Almond: 24x24 tile, 24x48 tile, 4x12 tile, 4x24 bullnose, Archetti 12x24 decor, hexagon mosaic, square mosaic.
Roma is produced at Del Conca USA's plant in Loudon, Tennessee, and ships from the factory.
Your cart is empty.